| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546474849505152535455 |
- EDT ft5x06 based Polytouch devices
- ----------------------------------
- The edt-ft5x06 driver is useful for the EDT "Polytouch" family of capacitive
- touch screens. Note that it is *not* suitable for other devices based on the
- focaltec ft5x06 devices, since they contain vendor-specific firmware. In
- particular this driver is not suitable for the Nook tablet.
- It has been tested with the following devices:
- * EP0350M06
- * EP0430M06
- * EP0570M06
- * EP0700M06
- The driver allows configuration of the touch screen via a set of sysfs files:
- /sys/class/input/eventX/device/device/threshold:
- allows setting the "click"-threshold in the range from 20 to 80.
- /sys/class/input/eventX/device/device/gain:
- allows setting the sensitivity in the range from 0 to 31. Note that
- lower values indicate higher sensitivity.
- /sys/class/input/eventX/device/device/offset:
- allows setting the edge compensation in the range from 0 to 31.
- /sys/class/input/eventX/device/device/report_rate:
- allows setting the report rate in the range from 3 to 14.
- For debugging purposes the driver provides a few files in the debug
- filesystem (if available in the kernel). In /sys/kernel/debug/edt_ft5x06
- you'll find the following files:
- num_x, num_y:
- (readonly) contains the number of sensor fields in X- and
- Y-direction.
- mode:
- allows switching the sensor between "factory mode" and "operation
- mode" by writing "1" or "0" to it. In factory mode (1) it is
- possible to get the raw data from the sensor. Note that in factory
- mode regular events don't get delivered and the options described
- above are unavailable.
- raw_data:
- contains num_x * num_y big endian 16 bit values describing the raw
- values for each sensor field. Note that each read() call on this
- files triggers a new readout. It is recommended to provide a buffer
- big enough to contain num_x * num_y * 2 bytes.
- Note that reading raw_data gives a I/O error when the device is not in factory
- mode. The same happens when reading/writing to the parameter files when the
- device is not in regular operation mode.
|
