| 123456789101112131415161718192021222324252627282930313233 |
- Kernel driver scx200_acb
- Author: Christer Weinigel <wingel@nano-system.com>
- The driver supersedes the older, never merged driver named i2c-nscacb.
- Module Parameters
- -----------------
- * base: up to 4 ints
- Base addresses for the ACCESS.bus controllers on SCx200 and SC1100 devices
- By default the driver uses two base addresses 0x820 and 0x840.
- If you want only one base address, specify the second as 0 so as to
- override this default.
- Description
- -----------
- Enable the use of the ACCESS.bus controller on the Geode SCx200 and
- SC1100 processors and the CS5535 and CS5536 Geode companion devices.
- Device-specific notes
- ---------------------
- The SC1100 WRAP boards are known to use base addresses 0x810 and 0x820.
- If the scx200_acb driver is built into the kernel, add the following
- parameter to your boot command line:
- scx200_acb.base=0x810,0x820
- If the scx200_acb driver is built as a module, add the following line to
- a configuration file in /etc/modprobe.d/ instead:
- options scx200_acb base=0x810,0x820
|
