regulator-quirk-rcar-gen2.c 4.0 KB

123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139
  1. /*
  2. * R-Car Generation 2 da9063/da9210 regulator quirk
  3. *
  4. * The r8a7790/lager and r8a7791/koelsch development boards have da9063 and
  5. * da9210 regulators. Both regulators have their interrupt request lines tied
  6. * to the same interrupt pin (IRQ2) on the SoC.
  7. *
  8. * After cold boot or da9063-induced restart, both the da9063 and da9210 seem
  9. * to assert their interrupt request lines. Hence as soon as one driver
  10. * requests this irq, it gets stuck in an interrupt storm, as it only manages
  11. * to deassert its own interrupt request line, and the other driver hasn't
  12. * installed an interrupt handler yet.
  13. *
  14. * To handle this, install a quirk that masks the interrupts in both the
  15. * da9063 and da9210. This quirk has to run after the i2c master driver has
  16. * been initialized, but before the i2c slave drivers are initialized.
  17. *
  18. * Copyright (C) 2015 Glider bvba
  19. *
  20. * This program is free software; you can redistribute it and/or modify
  21. * it under the terms of the GNU General Public License as published by
  22. * the Free Software Foundation; version 2 of the License.
  23. *
  24. * This program is distributed in the hope that it will be useful,
  25. * but WITHOUT ANY WARRANTY; without even the implied warranty of
  26. * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
  27. * GNU General Public License for more details.
  28. */
  29. #include <linux/device.h>
  30. #include <linux/i2c.h>
  31. #include <linux/init.h>
  32. #include <linux/io.h>
  33. #include <linux/notifier.h>
  34. #include <linux/of.h>
  35. #include <linux/mfd/da9063/registers.h>
  36. #define IRQC_BASE 0xe61c0000
  37. #define IRQC_MONITOR 0x104 /* IRQn Signal Level Monitor Register */
  38. #define REGULATOR_IRQ_MASK BIT(2) /* IRQ2, active low */
  39. /* start of DA9210 System Control and Event Registers */
  40. #define DA9210_REG_MASK_A 0x54
  41. static void __iomem *irqc;
  42. /* first byte sets the memory pointer, following are consecutive reg values */
  43. static u8 da9063_irq_clr[] = { DA9063_REG_IRQ_MASK_A, 0xff, 0xff, 0xff, 0xff };
  44. static u8 da9210_irq_clr[] = { DA9210_REG_MASK_A, 0xff, 0xff };
  45. static struct i2c_msg da9xxx_msgs[2] = {
  46. {
  47. .addr = 0x58,
  48. .len = ARRAY_SIZE(da9063_irq_clr),
  49. .buf = da9063_irq_clr,
  50. }, {
  51. .addr = 0x68,
  52. .len = ARRAY_SIZE(da9210_irq_clr),
  53. .buf = da9210_irq_clr,
  54. },
  55. };
  56. static int regulator_quirk_notify(struct notifier_block *nb,
  57. unsigned long action, void *data)
  58. {
  59. struct device *dev = data;
  60. struct i2c_client *client;
  61. u32 mon;
  62. mon = ioread32(irqc + IRQC_MONITOR);
  63. dev_dbg(dev, "%s: %ld, IRQC_MONITOR = 0x%x\n", __func__, action, mon);
  64. if (mon & REGULATOR_IRQ_MASK)
  65. goto remove;
  66. if (action != BUS_NOTIFY_ADD_DEVICE || dev->type == &i2c_adapter_type)
  67. return 0;
  68. client = to_i2c_client(dev);
  69. dev_dbg(dev, "Detected %s\n", client->name);
  70. if ((client->addr == 0x58 && !strcmp(client->name, "da9063")) ||
  71. (client->addr == 0x68 && !strcmp(client->name, "da9210"))) {
  72. int ret;
  73. dev_info(&client->dev, "clearing da9063/da9210 interrupts\n");
  74. ret = i2c_transfer(client->adapter, da9xxx_msgs, ARRAY_SIZE(da9xxx_msgs));
  75. if (ret != ARRAY_SIZE(da9xxx_msgs))
  76. dev_err(&client->dev, "i2c error %d\n", ret);
  77. }
  78. mon = ioread32(irqc + IRQC_MONITOR);
  79. if (mon & REGULATOR_IRQ_MASK)
  80. goto remove;
  81. return 0;
  82. remove:
  83. dev_info(dev, "IRQ2 is not asserted, removing quirk\n");
  84. bus_unregister_notifier(&i2c_bus_type, nb);
  85. iounmap(irqc);
  86. return 0;
  87. }
  88. static struct notifier_block regulator_quirk_nb = {
  89. .notifier_call = regulator_quirk_notify
  90. };
  91. static int __init rcar_gen2_regulator_quirk(void)
  92. {
  93. u32 mon;
  94. if (!of_machine_is_compatible("renesas,koelsch") &&
  95. !of_machine_is_compatible("renesas,lager") &&
  96. !of_machine_is_compatible("renesas,gose"))
  97. return -ENODEV;
  98. irqc = ioremap(IRQC_BASE, PAGE_SIZE);
  99. if (!irqc)
  100. return -ENOMEM;
  101. mon = ioread32(irqc + IRQC_MONITOR);
  102. if (mon & REGULATOR_IRQ_MASK) {
  103. pr_debug("%s: IRQ2 is not asserted, not installing quirk\n",
  104. __func__);
  105. iounmap(irqc);
  106. return 0;
  107. }
  108. pr_info("IRQ2 is asserted, installing da9063/da9210 regulator quirk\n");
  109. bus_register_notifier(&i2c_bus_type, &regulator_quirk_nb);
  110. return 0;
  111. }
  112. arch_initcall(rcar_gen2_regulator_quirk);