| 12345678910111213141516171819202122232425262728293031323334 |
- #ifndef SERPROG_H
- #define SERPROG_H
- /* According to Serial Flasher Protocol Specification - version 1 */
- #define S_ACK 0x06
- #define S_NAK 0x15
- #define S_CMD_NOP 0x00 /* No operation */
- #define S_CMD_Q_IFACE 0x01 /* Query interface version */
- #define S_CMD_Q_CMDMAP 0x02 /* Query supported commands bitmap */
- #define S_CMD_Q_PGMNAME 0x03 /* Query programmer name */
- #define S_CMD_Q_SERBUF 0x04 /* Query Serial Buffer Size */
- #define S_CMD_Q_BUSTYPE 0x05 /* Query supported bustypes */
- #define S_CMD_Q_CHIPSIZE 0x06 /* Query supported chipsize (2^n format) */
- #define S_CMD_Q_OPBUF 0x07 /* Query operation buffer size */
- #define S_CMD_Q_WRNMAXLEN 0x08 /* Query Write to opbuf: Write-N maximum length */
- #define S_CMD_R_BYTE 0x09 /* Read a single byte */
- #define S_CMD_R_NBYTES 0x0A /* Read n bytes */
- #define S_CMD_O_INIT 0x0B /* Initialize operation buffer */
- #define S_CMD_O_WRITEB 0x0C /* Write opbuf: Write byte with address */
- #define S_CMD_O_WRITEN 0x0D /* Write to opbuf: Write-N */
- #define S_CMD_O_DELAY 0x0E /* Write opbuf: udelay */
- #define S_CMD_O_EXEC 0x0F /* Execute operation buffer */
- #define S_CMD_SYNCNOP 0x10 /* Special no-operation that returns NAK+ACK */
- #define S_CMD_Q_RDNMAXLEN 0x11 /* Query read-n maximum length */
- #define S_CMD_S_BUSTYPE 0x12 /* Set used bustype(s). */
- #define S_CMD_O_SPIOP 0x13 /* Perform SPI operation. */
- #define S_CMD_S_SPI_FREQ 0x14 /* Set SPI clock frequency */
- #define S_CMD_S_PIN_STATE 0x15 /* Enable/disable output drivers */
- #define S_CMD_S_SPI_CS 0x16 /* Select Chip Select to use */
- #endif
|
