| 123456789101112131415161718192021222324252627282930313233343536 |
- * NXP Semiconductors NXP NCI NFC Controllers
- Required properties:
- - compatible: Should be "nxp,nxp-nci-i2c".
- - clock-frequency: I²C work frequency.
- - reg: address on the bus
- - interrupt-parent: phandle for the interrupt gpio controller
- - interrupts: GPIO interrupt to which the chip is connected
- - enable-gpios: Output GPIO pin used for enabling/disabling the chip
- - firmware-gpios: Output GPIO pin used to enter firmware download mode
- Optional SoC Specific Properties:
- - pinctrl-names: Contains only one value - "default".
- - pintctrl-0: Specifies the pin control groups used for this controller.
- Example (for ARM-based BeagleBone with NPC100 NFC controller on I2C2):
- &i2c2 {
- status = "okay";
- npc100: npc100@29 {
- compatible = "nxp,nxp-nci-i2c";
- reg = <0x29>;
- clock-frequency = <100000>;
- interrupt-parent = <&gpio1>;
- interrupts = <29 GPIO_ACTIVE_HIGH>;
- enable-gpios = <&gpio0 30 GPIO_ACTIVE_HIGH>;
- firmware-gpios = <&gpio0 31 GPIO_ACTIVE_HIGH>;
- };
- };
|
