| 12345678910111213141516171819202122232425262728293031323334 |
- Samsung S5K6A3(YX) raw image sensor
- ---------------------------------
- S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
- and CCI (I2C compatible) control bus.
- Required properties:
- - compatible : "samsung,s5k6a3";
- - reg : I2C slave address of the sensor;
- - svdda-supply : core voltage supply;
- - svddio-supply : I/O voltage supply;
- - afvdd-supply : AF (actuator) voltage supply;
- - gpios : specifier of a GPIO connected to the RESET pin;
- - clocks : should contain list of phandle and clock specifier pairs
- according to common clock bindings for the clocks described
- in the clock-names property;
- - clock-names : should contain "extclk" entry for the sensor's EXTCLK clock;
- Optional properties:
- - clock-frequency : the frequency at which the "extclk" clock should be
- configured to operate, in Hz; if this property is not
- specified default 24 MHz value will be used.
- The common video interfaces bindings (see video-interfaces.txt) should be
- used to specify link to the image data receiver. The S5K6A3(YX) device
- node should contain one 'port' child node with an 'endpoint' subnode.
- Following properties are valid for the endpoint node:
- - data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
- video-interfaces.txt. The sensor supports only one data lane.
|
