| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990 |
- # SPDX-License-Identifier: GPL-2.0-only
- # 64-bit ARM SoCs from TI
- if ARM64
- if ARCH_K3
- config ARCH_K3_AM6_SOC
- bool "K3 AM6 SoC"
- help
- Enable support for TI's AM6 SoC Family support
- config ARCH_K3_J721E_SOC
- bool "K3 J721E SoC"
- help
- Enable support for TI's J721E SoC Family support
- endif
- endif
- #
- # TI SOC drivers
- #
- menuconfig SOC_TI
- bool "TI SOC drivers support"
- if SOC_TI
- config KEYSTONE_NAVIGATOR_QMSS
- tristate "Keystone Queue Manager Sub System"
- depends on ARCH_KEYSTONE
- help
- Say y here to support the Keystone multicore Navigator Queue
- Manager support. The Queue Manager is a hardware module that
- is responsible for accelerating management of the packet queues.
- Packets are queued/de-queued by writing/reading descriptor address
- to a particular memory mapped location in the Queue Manager module.
- If unsure, say N.
- config KEYSTONE_NAVIGATOR_DMA
- tristate "TI Keystone Navigator Packet DMA support"
- depends on ARCH_KEYSTONE
- help
- Say y tp enable support for the Keystone Navigator Packet DMA on
- on Keystone family of devices. It sets up the dma channels for the
- Queue Manager Sub System.
- If unsure, say N.
- config AMX3_PM
- tristate "AMx3 Power Management"
- depends on SOC_AM33XX || SOC_AM43XX
- depends on WKUP_M3_IPC && TI_EMIF_SRAM && SRAM && RTC_DRV_OMAP
- help
- Enable power management on AM335x and AM437x. Required for suspend to mem
- and standby states on both AM335x and AM437x platforms and for deeper cpuidle
- c-states on AM335x. Also required for rtc and ddr in self-refresh low
- power mode on AM437x platforms.
- config WKUP_M3_IPC
- tristate "TI AMx3 Wkup-M3 IPC Driver"
- depends on WKUP_M3_RPROC
- depends on OMAP2PLUS_MBOX
- help
- TI AM33XX and AM43XX have a Cortex M3, the Wakeup M3, to handle
- low power transitions. This IPC driver provides the necessary API
- to communicate and use the Wakeup M3 for PM features like suspend
- resume and boots it using wkup_m3_rproc driver.
- config TI_SCI_PM_DOMAINS
- tristate "TI SCI PM Domains Driver"
- depends on TI_SCI_PROTOCOL
- depends on PM_GENERIC_DOMAINS
- help
- Generic power domain implementation for TI device implementing
- the TI SCI protocol.
- To compile this as a module, choose M here. The module will be
- called ti_sci_pm_domains. Note this is needed early in boot before
- rootfs may be available.
- endif # SOC_TI
- config TI_SCI_INTA_MSI_DOMAIN
- bool
- select GENERIC_MSI_IRQ_DOMAIN
- help
- Driver to enable Interrupt Aggregator specific MSI Domain.
|
