123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778798081828384858687888990919293949596979899100101102103104105106107108109110111112113114115116117118119120121122123124125126127128129130131132133134135136137138139140141142143144145146147148149150151152153154155156157158159160161162163164165166167168169170171172173174175176177178179180181182183184185186187188189190191192193194195196197198199200201202203204205206207208209210211212213214215216217218219220221222223224225226227228229230231232233234235236237238239240241242243244245246247248249250251252253254255256257258259260261262263264265266267268269270271272273274275276277278279280281282283284285286287288289290291292293294295296297298299300301302303304305306307308309310311312313314315316317318319320321322323324325326327328329330331332333334335336337338339340341342343344345346347348349350351352353354355356357358359360361362 |
- /*
- * Watchdog driver for SiByte SB1 SoCs
- *
- * Copyright (C) 2007 OnStor, Inc. * Andrew Sharp <andy.sharp@lsi.com>
- *
- * This driver is intended to make the second of two hardware watchdogs
- * on the Sibyte 12XX and 11XX SoCs available to the user. There are two
- * such devices available on the SoC, but it seems that there isn't an
- * enumeration class for watchdogs in Linux like there is for RTCs.
- * The second is used rather than the first because it uses IRQ 1,
- * thereby avoiding all that IRQ 0 problematic nonsense.
- *
- * I have not tried this driver on a 1480 processor; it might work
- * just well enough to really screw things up.
- *
- * It is a simple timer, and there is an interrupt that is raised the
- * first time the timer expires. The second time it expires, the chip
- * is reset and there is no way to redirect that NMI. Which could
- * be problematic in some cases where this chip is sitting on the HT
- * bus and has just taken responsibility for providing a cache block.
- * Since the reset can't be redirected to the external reset pin, it is
- * possible that other HT connected processors might hang and not reset.
- * For Linux, a soft reset would probably be even worse than a hard reset.
- * There you have it.
- *
- * The timer takes 23 bits of a 64 bit register (?) as a count value,
- * and decrements the count every microsecond, for a max value of
- * 0x7fffff usec or about 8.3ish seconds.
- *
- * This watchdog borrows some user semantics from the softdog driver,
- * in that if you close the fd, it leaves the watchdog running, unless
- * you previously wrote a 'V' to the fd, in which case it disables
- * the watchdog when you close the fd like some other drivers.
- *
- * Based on various other watchdog drivers, which are probably all
- * loosely based on something Alan Cox wrote years ago.
- *
- * (c) Copyright 1996 Alan Cox <alan@lxorguk.ukuu.org.uk>,
- * All Rights Reserved.
- *
- * This program is free software; you can redistribute it and/or
- * modify it under the terms of the GNU General Public License
- * version 1 or 2 as published by the Free Software Foundation.
- *
- */
- #define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
- #include <linux/module.h>
- #include <linux/io.h>
- #include <linux/uaccess.h>
- #include <linux/fs.h>
- #include <linux/reboot.h>
- #include <linux/miscdevice.h>
- #include <linux/watchdog.h>
- #include <linux/interrupt.h>
- #include <asm/sibyte/sb1250.h>
- #include <asm/sibyte/sb1250_regs.h>
- #include <asm/sibyte/sb1250_int.h>
- #include <asm/sibyte/sb1250_scd.h>
- static DEFINE_SPINLOCK(sbwd_lock);
- /*
- * set the initial count value of a timer
- *
- * wdog is the iomem address of the cfg register
- */
- void sbwdog_set(char __iomem *wdog, unsigned long t)
- {
- spin_lock(&sbwd_lock);
- __raw_writeb(0, wdog);
- __raw_writeq(t & 0x7fffffUL, wdog - 0x10);
- spin_unlock(&sbwd_lock);
- }
- /*
- * cause the timer to [re]load it's initial count and start counting
- * all over again
- *
- * wdog is the iomem address of the cfg register
- */
- void sbwdog_pet(char __iomem *wdog)
- {
- spin_lock(&sbwd_lock);
- __raw_writeb(__raw_readb(wdog) | 1, wdog);
- spin_unlock(&sbwd_lock);
- }
- static unsigned long sbwdog_gate; /* keeps it to one thread only */
- static char __iomem *kern_dog = (char __iomem *)(IO_BASE + (A_SCD_WDOG_CFG_0));
- static char __iomem *user_dog = (char __iomem *)(IO_BASE + (A_SCD_WDOG_CFG_1));
- static unsigned long timeout = 0x7fffffUL; /* useconds: 8.3ish secs. */
- static int expect_close;
- static const struct watchdog_info ident = {
- .options = WDIOF_CARDRESET | WDIOF_SETTIMEOUT |
- WDIOF_KEEPALIVEPING | WDIOF_MAGICCLOSE,
- .identity = "SiByte Watchdog",
- };
- /*
- * Allow only a single thread to walk the dog
- */
- static int sbwdog_open(struct inode *inode, struct file *file)
- {
- nonseekable_open(inode, file);
- if (test_and_set_bit(0, &sbwdog_gate))
- return -EBUSY;
- __module_get(THIS_MODULE);
- /*
- * Activate the timer
- */
- sbwdog_set(user_dog, timeout);
- __raw_writeb(1, user_dog);
- return 0;
- }
- /*
- * Put the dog back in the kennel.
- */
- static int sbwdog_release(struct inode *inode, struct file *file)
- {
- if (expect_close == 42) {
- __raw_writeb(0, user_dog);
- module_put(THIS_MODULE);
- } else {
- pr_crit("%s: Unexpected close, not stopping watchdog!\n",
- ident.identity);
- sbwdog_pet(user_dog);
- }
- clear_bit(0, &sbwdog_gate);
- expect_close = 0;
- return 0;
- }
- /*
- * 42 - the answer
- */
- static ssize_t sbwdog_write(struct file *file, const char __user *data,
- size_t len, loff_t *ppos)
- {
- int i;
- if (len) {
- /*
- * restart the timer
- */
- expect_close = 0;
- for (i = 0; i != len; i++) {
- char c;
- if (get_user(c, data + i))
- return -EFAULT;
- if (c == 'V')
- expect_close = 42;
- }
- sbwdog_pet(user_dog);
- }
- return len;
- }
- static long sbwdog_ioctl(struct file *file, unsigned int cmd,
- unsigned long arg)
- {
- int ret = -ENOTTY;
- unsigned long time;
- void __user *argp = (void __user *)arg;
- int __user *p = argp;
- switch (cmd) {
- case WDIOC_GETSUPPORT:
- ret = copy_to_user(argp, &ident, sizeof(ident)) ? -EFAULT : 0;
- break;
- case WDIOC_GETSTATUS:
- case WDIOC_GETBOOTSTATUS:
- ret = put_user(0, p);
- break;
- case WDIOC_KEEPALIVE:
- sbwdog_pet(user_dog);
- ret = 0;
- break;
- case WDIOC_SETTIMEOUT:
- ret = get_user(time, p);
- if (ret)
- break;
- time *= 1000000;
- if (time > 0x7fffffUL) {
- ret = -EINVAL;
- break;
- }
- timeout = time;
- sbwdog_set(user_dog, timeout);
- sbwdog_pet(user_dog);
- case WDIOC_GETTIMEOUT:
- /*
- * get the remaining count from the ... count register
- * which is 1*8 before the config register
- */
- ret = put_user((u32)__raw_readq(user_dog - 8) / 1000000, p);
- break;
- }
- return ret;
- }
- /*
- * Notifier for system down
- */
- static int sbwdog_notify_sys(struct notifier_block *this, unsigned long code,
- void *erf)
- {
- if (code == SYS_DOWN || code == SYS_HALT) {
- /*
- * sit and sit
- */
- __raw_writeb(0, user_dog);
- __raw_writeb(0, kern_dog);
- }
- return NOTIFY_DONE;
- }
- static const struct file_operations sbwdog_fops = {
- .owner = THIS_MODULE,
- .llseek = no_llseek,
- .write = sbwdog_write,
- .unlocked_ioctl = sbwdog_ioctl,
- .open = sbwdog_open,
- .release = sbwdog_release,
- };
- static struct miscdevice sbwdog_miscdev = {
- .minor = WATCHDOG_MINOR,
- .name = "watchdog",
- .fops = &sbwdog_fops,
- };
- static struct notifier_block sbwdog_notifier = {
- .notifier_call = sbwdog_notify_sys,
- };
- /*
- * interrupt handler
- *
- * doesn't do a whole lot for user, but oh so cleverly written so kernel
- * code can use it to re-up the watchdog, thereby saving the kernel from
- * having to create and maintain a timer, just to tickle another timer,
- * which is just so wrong.
- */
- irqreturn_t sbwdog_interrupt(int irq, void *addr)
- {
- unsigned long wd_init;
- char *wd_cfg_reg = (char *)addr;
- u8 cfg;
- cfg = __raw_readb(wd_cfg_reg);
- wd_init = __raw_readq(wd_cfg_reg - 8) & 0x7fffff;
- /*
- * if it's the second watchdog timer, it's for those users
- */
- if (wd_cfg_reg == user_dog)
- pr_crit("%s in danger of initiating system reset "
- "in %ld.%01ld seconds\n",
- ident.identity,
- wd_init / 1000000, (wd_init / 100000) % 10);
- else
- cfg |= 1;
- __raw_writeb(cfg, wd_cfg_reg);
- return IRQ_HANDLED;
- }
- static int __init sbwdog_init(void)
- {
- int ret;
- /*
- * register a reboot notifier
- */
- ret = register_reboot_notifier(&sbwdog_notifier);
- if (ret) {
- pr_err("%s: cannot register reboot notifier (err=%d)\n",
- ident.identity, ret);
- return ret;
- }
- /*
- * get the resources
- */
- ret = request_irq(1, sbwdog_interrupt, IRQF_SHARED,
- ident.identity, (void *)user_dog);
- if (ret) {
- pr_err("%s: failed to request irq 1 - %d\n",
- ident.identity, ret);
- goto out;
- }
- ret = misc_register(&sbwdog_miscdev);
- if (ret == 0) {
- pr_info("%s: timeout is %ld.%ld secs\n",
- ident.identity,
- timeout / 1000000, (timeout / 100000) % 10);
- return 0;
- }
- free_irq(1, (void *)user_dog);
- out:
- unregister_reboot_notifier(&sbwdog_notifier);
- return ret;
- }
- static void __exit sbwdog_exit(void)
- {
- misc_deregister(&sbwdog_miscdev);
- free_irq(1, (void *)user_dog);
- unregister_reboot_notifier(&sbwdog_notifier);
- }
- module_init(sbwdog_init);
- module_exit(sbwdog_exit);
- MODULE_AUTHOR("Andrew Sharp <andy.sharp@lsi.com>");
- MODULE_DESCRIPTION("SiByte Watchdog");
- module_param(timeout, ulong, 0);
- MODULE_PARM_DESC(timeout,
- "Watchdog timeout in microseconds (max/default 8388607 or 8.3ish secs)");
- MODULE_LICENSE("GPL");
- /*
- * example code that can be put in a platform code area to utilize the
- * first watchdog timer for the kernels own purpose.
- void platform_wd_setup(void)
- {
- int ret;
- ret = request_irq(1, sbwdog_interrupt, IRQF_SHARED,
- "Kernel Watchdog", IOADDR(A_SCD_WDOG_CFG_0));
- if (ret) {
- pr_crit("Watchdog IRQ zero(0) failed to be requested - %d\n", ret);
- }
- }
- */
|