| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172737475767778 |
- config IR_IMG
- tristate "ImgTec IR Decoder"
- depends on RC_CORE
- depends on MIPS || COMPILE_TEST
- select IR_IMG_HW if !IR_IMG_RAW
- help
- Say Y or M here if you want to use the ImgTec infrared decoder
- functionality found in SoCs such as TZ1090.
- config IR_IMG_RAW
- bool "Raw decoder"
- depends on IR_IMG
- help
- Say Y here to enable the raw mode driver which passes raw IR signal
- changes to the IR raw decoders for software decoding. This is much
- less reliable (due to lack of timestamps) and consumes more
- processing power than using hardware decode, but can be useful for
- testing, debug, and to make more protocols available.
- config IR_IMG_HW
- bool "Hardware decoder"
- depends on IR_IMG
- help
- Say Y here to enable the hardware decode driver which decodes the IR
- signals in hardware. This is more reliable, consumes less processing
- power since only a single interrupt is received for each scancode,
- and allows an IR scancode to be used as a wake event.
- config IR_IMG_NEC
- bool "NEC protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the NEC, extended NEC, and 32-bit
- NEC protocols in the ImgTec infrared decoder block.
- config IR_IMG_JVC
- bool "JVC protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the JVC protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SONY
- bool "Sony protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sony protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SHARP
- bool "Sharp protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sharp protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_SANYO
- bool "Sanyo protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the Sanyo protocol (used by Sanyo,
- Aiwa, Chinon remotes) in the ImgTec infrared decoder block.
- config IR_IMG_RC5
- bool "Philips RC5 protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the RC5 protocol in the ImgTec
- infrared decoder block.
- config IR_IMG_RC6
- bool "Philips RC6 protocol support"
- depends on IR_IMG_HW
- help
- Say Y here to enable support for the RC6 protocol in the ImgTec
- infrared decoder block.
- Note: This version only supports mode 0.
|
