| 123456789101112131415161718192021222324252627282930313233343536373839404142434445464748495051525354555657585960616263646566676869707172 |
- menuconfig MTD_ONENAND
- tristate "OneNAND Device Support"
- depends on MTD
- depends on HAS_IOMEM
- help
- This enables support for accessing all type of OneNAND flash
- devices.
- if MTD_ONENAND
- config MTD_ONENAND_VERIFY_WRITE
- bool "Verify OneNAND page writes"
- help
- This adds an extra check when data is written to the flash. The
- OneNAND flash device internally checks only bits transitioning
- from 1 to 0. There is a rare possibility that even though the
- device thinks the write was successful, a bit could have been
- flipped accidentally due to device wear or something else.
- config MTD_ONENAND_GENERIC
- tristate "OneNAND Flash device via platform device driver"
- help
- Support for OneNAND flash via platform device driver.
- config MTD_ONENAND_OMAP2
- tristate "OneNAND on OMAP2/OMAP3 support"
- depends on ARCH_OMAP2 || ARCH_OMAP3
- depends on OF || COMPILE_TEST
- help
- Support for a OneNAND flash device connected to an OMAP2/OMAP3 SoC
- via the GPMC memory controller.
- Enable dmaengine and gpiolib for better performance.
- config MTD_ONENAND_SAMSUNG
- tristate "OneNAND on Samsung SOC controller support"
- depends on ARCH_S3C64XX || ARCH_S5PV210 || ARCH_EXYNOS4
- help
- Support for a OneNAND flash device connected to an Samsung SOC.
- S3C64XX uses command mapping method.
- S5PC110/S5PC210 use generic OneNAND method.
- config MTD_ONENAND_OTP
- bool "OneNAND OTP Support"
- help
- One Block of the NAND Flash Array memory is reserved as
- a One-Time Programmable Block memory area.
- Also, 1st Block of NAND Flash Array can be used as OTP.
- The OTP block can be read, programmed and locked using the same
- operations as any other NAND Flash Array memory block.
- OTP block cannot be erased.
- OTP block is fully-guaranteed to be a valid block.
- config MTD_ONENAND_2X_PROGRAM
- bool "OneNAND 2X program support"
- help
- The 2X Program is an extension of Program Operation.
- Since the device is equipped with two DataRAMs, and two-plane NAND
- Flash memory array, these two component enables simultaneous program
- of 4KiB. Plane1 has only even blocks such as block0, block2, block4
- while Plane2 has only odd blocks such as block1, block3, block5.
- So MTD regards it as 4KiB page size and 256KiB block size
- Now the following chips support it. (KFXXX16Q2M)
- Demux: KFG2G16Q2M, KFH4G16Q2M, KFW8G16Q2M,
- Mux: KFM2G16Q2M, KFN4G16Q2M,
- And more recent chips
- endif # MTD_ONENAND
|
